Transmitter Switch Settings
1 2 3 |
4 5 6 |
7 8 9 |
10 11 12 |
up |
up |
up |
7 |
up |
up |
down |
6 |
up |
down |
up |
5 |
up |
down |
down |
4 |
down |
up |
up |
3 |
down |
up |
down |
2 |
down |
down |
up |
1 |
down |
down |
down |
0 |
Resulting Security Code
___ ___ ___ ___ PLEASE
NOTE:
DURING 2000, THE
FACTORY MODIFIED
THIS KEYPAD.
IF THE KEYPAD DOES
NOT WORK AFTER
FOLLOWING THESE
DIRECTIONS - TRY
REPEATING THE
DIRECTIONS
BUT SKIP STEP #2 |
Always disconnect operator from door before programming
to avoid injury to yourself or the operator
OVERHEAD DOOR • "G" Series Non-CodeDodger OR GENIE • Wireless (slide up cover)
Battery: Access Panel is at the bottom edge of the keypad.
To Operate: Depress area and slide down. Light should come on when cover is raised.
Reset Keypad:
- Open cover on keypad just enough to press
"#" & "8" at the same time. While pressing these keys, raise the cover all the way (this erases the old code). Release the buttons.
- Close the cover. Open cover fully.
- Press numbers "3", "5", "7", and "#". The red light should be blinking about once a second.
- Enter your new PIN number and press #. The red light should be blinking
faster.
- Enter the security code number and press "*"- red Light will turn off.
- Close keypad cover fully.
- Slide keypad cover open fully and enter the pin number and press "*" to test with your new code number.
To Change Pin # Without Resetting Keypad:
- Open cover fully.
- Enter OLD pin number and press "#" - red light will blink slowly.
- Enter the NEW pin number and press "#" - red light will blink faster.
- Press "*" - red light will turn off.
- Close keypad cover.
- Slide keypad cover open fully and enter pin number and press "*" to test with your new code number.
NOTE: On a 456 Operator, press the far right button in the cut-out area to program a new transmitter. THIS IS FOR "O-SERIES" TRANSMITTERS ONLY.
|
